Hi all, Without getting too specific about my model (which is added at the end of this post) I am getting a result that I never had before. If I test-run my model on 1 chain, the MC error is very low, looking like it converges. However, when I do an actual run over multiple chains, the parameters d…

Low MC error per chain, but no convergence of chains

avdminne April 22, 2021, 12:29pm 3

Ha thanks,

actually, that post you recommended shows the exact same issue I have, plus some tips. I’ll delve into it.
Many thanks.

1 Like

Model comparison - lp__

Topic		Replies	Views
Convergence issues of MCMC Modeling fitting-issues	17	4025	May 22, 2019
Convergence within chains, but not across chains Modeling fitting-issues , stan	3	1399	March 20, 2021
Multiple cycles in which part of the chain does not converge Modeling	7	805	December 28, 2020
Multiple Chains do not converge Modeling	1	2076	July 4, 2019
Inconsistent chain speed - does this give a clue about the problem? Algorithms optimization	10	4577	July 20, 2018